200-401 Exam Training Practice Tests (Cisco Managing Industrial Networks with Cisco Networking Technologies)]

Question 1

With a Cisco IE 2000 switch, what does a port status LED indicate when it is alternating green and amber?

A. The port is not forwarding. B. A link is present. C. There is a link fault. D. No link is present. E. The port is sending or receiving data.

Correct Answer: C

Question 2

Which of the following correctly pairs the dotted decimal subnet mask with the correct number of binary bits that represent the subnet mask?

A. 255.255.255.248 and /28 B. 255.255.255.240 and /28 C. 255.255.255.248 and /27 D. 255.255.255.192 and /25 E. 255.255.255.240 and /16 F. 255.255.255.224 and /26

Correct Answer: B

Question 3

At which Layer would you check for spanning tree loops?

A. Layer 4 B. Layer 1 C. Layer 2 D. Layer 3

Correct Answer: C

Question 4

Which two commands can help you to determine what image is running on your industrial switch? (Choose two.)

A. show interfaces gigabitEthernet x/y switchport B. show interface-switch C. show spanning-tree D. show license E. show version

Correct Answer: D,E

Question 5

You are troubleshooting a connectivity problem and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. Which command would you issue to see where the packets stop?

A. router#ping B. router#show ip route C. router#traceroute D. router#show cdp neighbors E. router#tracert

Correct Answer: C

Question 6

Which two reasons make mesh bonding systems most effective? (Choose two.)

A. provide additional strength to floor structures B. cover wide areas C. create equipotential grounding systems D. provide low-impedance noise-equalizing paths E. most cost-effective approach

Correct Answer: C,D

Question 7

Exhibit:

Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the VLANs. All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway. What is true about this configuration?

A. These commands need to be added to the configuration:C-router(config)# router eigrp 123C-router(config-router)# network 172.19.0.0 B. These commands need to be added to the configuration:C-router(config)# router ripCrouter(config-router)# network 172.19.0.0 C. No further routing configuration is required. D. These commands need to be added to the configuration:C-router(config)# router ospf 1C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0

Correct Answer: C

Cisco Managing Industrial Networks with Cisco Networking Technologies - 200-401 Exam Practice Test