640-692 Exam Training Practice Tests (Cisco Supporting Cisco Routing and Switching Network Devices)]

Question 1

When using a modem to provide out-of-band access to a Cisco router, which cable is used to connect the modem to the router?

A. DB-45 to RJ-45 B. DB-9 to RJ-45 C. DB-25 to RJ-45 D. RJ-44 to RJ-45 E. RJ-45 to RJ-45

Correct Answer: C

Question 2

Which IEEE standard protocol is initiated as a result of successful DTP completion in a switch over Fast Ethernet?

A. 802.1D B. 802.1w C. 802.1Q D. 802.3ad

Correct Answer: C

Question 3

Which command sends an echo request packet to the largest host and then waits for an echo response message?

A. access B. echo C. ping D. connect E. telnet

Correct Answer: C

Question 4

Which two of the following are component of WAN connection? (Choose two)

A. router B. switch C. Hub D. CSU/DSU E. Bridge

Correct Answer: A,D

Question 5

How does a Cisco switch respond if you boot it without a valid configuration in the NVRAM?

A. It prompts you to restore the startup configuration B. it enters setup mode. C. it enters user EXEC mode. D. it uses the running -configuration

Correct Answer: D

Question 6

Which two of the following are features of NVRAM on a Cisco device? (Choose two)

A. Stores routing tables B. Erased when device is rebooted C. Not erased when device is rebooted D. Stores decompressed IOS software image E. Stores running configuration F. Stores startup configuration

Correct Answer: C,F

Question 7

Refer to the exhibit.

What does the CD LED indicate on the voice WAN interface card?

A. The interface is in loopback mode B. An alarm condition C. A carrier has been detected D. Receive signal strength

Correct Answer: C

Question 8

Which three of the following describe Fast Ethernet? (Choose three)

A. 100BASE-T B. requires Category 3 or higher UTP cabling C. 100-Mb/s speed D. 1QBASE-T H B E. 10-Mb/s speed F. requires Category 5 or higher UTP cabling

Correct Answer: A,C,F

Question 9

Which port displays the bootup process on a Cisco device?

A. BVI B. ATM C. Ethernet D. Console

Correct Answer: D

Question 10

Refer to the exhibit.

Why is flash memory erased prior to upgrading the IOS image from the TFTP server?

A. In order for the router to use the new image as the default, it must be the only IOS image in flash. B. The router cannot verify that the Cisco IOS image currently in flash is valid. C. Erasing current flash content is requested during the copy dialog. D. Flash memory on Cisco routers can contain only a single IOS image.

Correct Answer: C

Cisco Supporting Cisco Routing and Switching Network Devices - 640-692 Exam Practice Test