CTS-I Exam Training Practice Tests (AVIXA Certified Technology Specialist

Question 1

What type of rack would you use for an AV event at a remote location?

A. Open-frame (gangable) rack B. Stand-alone rack C. Portable rack with casters D. Portable shock-mounted rack with casters

Correct Answer: D

Question 2

What type of termination technique is used for a solid conductor RJ45 connector?

A. Compression B. Crimp C. Solder D. Insulation displacement

Correct Answer: D

Question 3

What method can a technician use onsite to verify that the AV device is set to the proper IP address?

A. Use a DVI-D connector and telnet into the device B. Use a USB connection to the CPU and the HyperTerminal program C. Connect directly to the CPU using an XLR connector and the Ping program D. Use a Serial Digital Interface to locate the IP

Correct Answer: B

Question 4

Which test verifies a signal can travel from one end of the cable to the other?

A. Continuity B. Polarity C. Impedance D. Insulation

Correct Answer: A

Question 5

Why should you avoid coiling power cables within a rack?

A. Coiled cables can make it difficult to service a rack. B. A coiled cord can become permanently kinked. C. Coiled cables don't look very tidy in a finished rack. D. Coiling power cords create a powerful electromagnetic field, which interferes with lower signal levels.

Correct Answer: D

Question 6

If there are _____ markings on the head of a bolt, it is a Grade 8 ASTM.

A. Two B. Three C. Six D. Five

Correct Answer: C

Question 7

Draws the video image on the display in a sequence of lines from top to bottom:

A. Frame rate B. Progressive scanning C. Refresh rate D. Interlaced scanning

Correct Answer: B

Question 8

When powering a system on, which device from the following list should you turn on last?

A. Pre-amplifiers B. Wireless mic receivers C. Blu-ray players D. Power amplifiers

Correct Answer: D

Question 9

What is a dependency within a project task schedule?

A. A task that must be completed by a specific date B. A task that will be required if specific conditions occur at the project site C. An optional task that the client can determine is needed once the project is underway D. A task that cannot begin before another task has been completed

Correct Answer: D

Question 10

A customer has recently added a second wireless microphone to an existing system. The customer now complains that the sound quality from both microphones has degraded. Of the following, which is the MOST LIKELY cause for the problem?

A. The existing wireless microphone is too old to be used with the new wireless microphone. B. The new wireless microphone shares a similar frequency as the old wireless microphone. C. The new wireless microphone is from a different manufacturer D. The old wireless microphone battery is dying.

Correct Answer: B

Question 11

Where are tall equipment racks usually mounted?

A. To a wall B. Equipment racks can't be mounted C. To the floor D. To the ceiling

Correct Answer: C

AVIXA Certified Technology Specialist - Installation - CTS-I Exam Practice Test