D-PCM-DY-23 Exam Training Practice Tests (EMC Dell PowerSwitch Campus Deploy 2023)]

Question 1

What is the IP protocol number, in decimal, assigned by IANA for VRRP?

A. 443 B. 25 C. 112 D. 1443

Correct Answer: C

Question 2

What is the PoE source maximum power budget for a Class 3 end device?

A. 60 watts B. 30 watts C. 15.4 watts D. 12.95 watts

Correct Answer: C

Question 3

What is the interaction between CDP, ISDP, and LLDP when communicating configuration information from a Dell EMC Campus networking switch to a Cisco VoIP phone?

A. N-Series switches can be configured to use LLDP or CDP to communicate configuration information with Cisco devices B. N-Series switches can be configured to use ISDP or LLDP to communicate configuration information with Cisco devices C. N-Series switches can be configured to use ISDP or CDP to communicate configuration information with Cisco devices D. N-Series switches can be configured to use only CDP to communicate configuration information with Cisco devices

Correct Answer: B

Question 4

What is the typical sequence of steps to upgrade the firmware of a Dell EMC N-Series switch?

Correct Answer:

Question 5

A network administrator has configured a 4-port port-channel between two Dell EMC Campus networking switches. The physical interfaces show as administratively up and operationally up on both switches. However, the port-channel shows as operationally up on Switch A and operationally down on Switch B.
What is a potential reason for the inconsistent port-channel state?

A. N-Series supports a maximum number of physical interfaces that can be included in port-channels on a per-device basis B. Switch A is configured using channel-group # mode on and Switch B is configured using channel- group # mode auto C. Ports in the port-channel on Switch A are all the same speed but the ports in the port- channel on Switch B are a mix of speeds D. Switch A is configured to use dynamic port-channels and Switch B is configured to use static port- channels

Correct Answer: B

Question 6

Which ports on a spanning tree root switch are always forwarding?

A. Backup ports B. Designated ports C. Alternate ports D. Root ports

Correct Answer: B

Question 7

Which L3 feature overrides routing protocol decisions and determines the forwarding of packets?

A. SVI B. RSTP C. PBR D. SMTP

Correct Answer: C

Question 8

Which command is used to display the current VLAN and switchport settings?

A. show interfaces traffic B. show vlan C. show interfaces switchport D. show interfaces status

Correct Answer: C

Question 9

To which destination MAC address are MLAG peer-keepalive packets sent?

A. 01:00:C5:00:00:00 B. C5:00:01:00:00:00 C. B5:00:01:00:00:00 D. 01:00:B5:00:00:00

Correct Answer: D

Question 10

Match the DSCP class selectors with their description.

Correct Answer:

Question 11

Which Dell PowerSwitch N-Series model supports the BGP and stack features?

A. N1124T-ON B. N3208PX-ON C. N3224T-ON D. N2224PX-ON

Correct Answer: C

Question 12

What describes VRRP advertisements?

A. Advertisements are sent from the Master router once every second by default B. Advertisements are sent from the Master router once every three seconds by default C. Advertisements are fixed values and cannot be changed D. Advertisements can be changed independently in the Master router regardless of the backup routers

Correct Answer: A

EMC Dell PowerSwitch Campus Deploy 2023 - D-PCM-DY-23 Exam Practice Test