EW0-200 Exam Training Practice Tests (Extreme Networks Extreme networks associate(ena))]

Question 1

Extreme Networks switches build their forwarding database from the incoming packet field information containing the

A. Destination IP address. B. Destination MAC address. C. Source IP address. D. Source MAC address.

Correct Answer: D

Question 2

The following console speeds are supported when a switch runs in bootROM mode. (Choose the two that apply)

A. 38400 bps B. 2400 bps C. 115200 bps D. 9600 bps

Correct Answer: A,D

Question 3

What command will provide you with information on SNMP statistics and SNMP access attempts?

A. Show epicenter B. Show switch C. Show snmp D. Show management

Correct Answer: D

Question 4

I/O modules for the BlackDiamond 6808 and Alpine 3804 switch products are interchangeable.

A. FALSE B. TRUE

Correct Answer: A

Question 5

What is true when VLAN corporate shows a protocol field with the value of NONE.

A. VLAN corporate will not forward any traffic. B. VLAN corporate must be a MAC-based VLAN. C. None of these. D. It is not possible for a VLAN to have NONE listed as the protocol.

Correct Answer: A

Question 6

The CLI command to prevent VLAN corporate from forwarding broadcast traffic for ports 2 2-2 6 is config vlan corporate add ports 2 2-2 6 nobroadcast.

A. FALSE B. TRUE

Correct Answer: B

Question 7

Exhibit:

What can possibly cause the error displayed in the exhibit?

A. An attempt was made to create another tagged VLAN for port 1. B. All of the above. C. An attempt was made to add a port to a port-based VLAN, where that port was already in use by another port-based VLAN. D. An attempt was made to add an IP address to port 1 when it was already configured with a protocol filter.

Correct Answer: C

Question 8

Which one of the following can populate an IP Route Table with its route entry on an Extreme switch?

A. Proxy ARP B. None of these. C. UDP-forwarding D. MAC Addresses

Correct Answer: B

Question 9

If you change and then forget the only remaining password for the CLI Administrator account ability to log on to an Extreme switch, how can you recover the password without loosing the configuration?

A. Contact the local Extreme Systems Engineer B. Provide dial-up, modem access to the switch console port for Extreme support to dial in C. You can RMA the switch and return to Extreme Corporate offices D. All of these

Correct Answer: D

Extreme Networks Extreme networks associate(ena) - EW0-200 Exam Practice Test