H12-211-ENU Exam Training Practice Tests (Huawei HCIA-Routing&Switching(Huawei Certified ICT Associate))]

Question 1

In Huawei AR routers, by default, the value of the RIP priority is?

A. 120 B. 60 C. 0 D. 100

Correct Answer: D

Question 2

The output information of the router interface is as follows. Which multicast address data can the interface receive? (Multiple choice)

A. FF02::2 B. FF02::1 C. FF02::1: FF12:1 D. FF02::1: FF6F:4F36

Correct Answer: A,B,C,D

Question 3

Which of the following description is wrong about the Layer 2 Ethernet switch?

A. Layer 2 Ethernet switch works at the data link layer B. Ability to learn MAC address C. It is necessary to make certain modifications to the three-layer header of the forwarded message, and then forward it. D. Forward according to the Layer 2 header information of the Ethernet frame

Correct Answer: C

Question 4

Which VLAN partitioning method is most appropriate when the host frequently moves the location?

A. Port-based partitioning B. Based on MAC address division C. Basic strategy division D. Based on IP subnetting

Correct Answer: B

Question 5

OSPFv2 supports IPv6 by adding new types of LSAs.

A. True B. False

Correct Answer: B

Question 6

What is the default server port number used by the Telnet protocol?

A. 22 B. 23 C. 21 D. 24

Correct Answer: B

Question 7

As shown in the broadcast network, OSPF runs on four routers and in the same area and on the same network segment. OSPF automatically elects a DR. Multiple BDRs to achieve better backup results.

A. True B. False

Correct Answer: B

Question 8

Which of the following fields are fields that exist in both IPv6 and IPv4 headers? (Multiple Choice)

A. Source Address B. Next Header C. Version D. Destination Address

Correct Answer: A,C,D

Question 9

As shown in the following figure, all routers run OSPF. Which device ABR?

A. Router B B. Router D C. Router C D. Router A

Correct Answer: A,D

Question 10

Which packet is sent by the DHCPv6 client in response to the Advertise packet sent by the DHCPv6 server?

A. Request B. Offer C. Advertise D. Reply

Correct Answer: A

Question 11

ip route-static 10.0.12.0 255.255.255.0 192.168.1.1
The correct description about this command is ().

A. This command configures a route to the 192.168.1.1 network. B. If the router learns the route of the same destination network as this route through other protocols, the router will prefer this route. C. This command configures a route to the 10.0.12.0 network. D. The priority of this route is 100.

Correct Answer: C

Question 12

Which authorization modes does AAA support on Huawei ARG3 series routers? (Multiple choice)

A. Not authorized B. HWTACACS authorization C. Authorization after successful RADIUS authentication D. Local authorization

Correct Answer: A,B,C,D

Question 13

Which message need to send when needing to terminate a PPPoE session?

A. PADT B. PADI C. PADR D. PADO

Correct Answer: A

Question 14

When configuring OSPF on a router, you must manually configure (). (Multiple Choice)

A. Enable OSPF process B. Create an OSPF area C. Configure the router ID D. Specify the network included in each zone

Correct Answer: A,B,D

Question 15

As shown in the following figure, what is the scope of AH protocol authentication in IPsec tunnel mode?

A. 4 B. 2 C. 1 D. 3

Correct Answer: A

Huawei HCIA-Routing&Switching(Huawei Certified ICT Associate) - H12-211-ENU Exam Practice Test