HP2-Z18 Exam Training Practice Tests (HP Network Infrastructure AIS 2011)]

Question 1

What is indicated by the-1 in the following prompt from an HP A-Series switch?
[Switch-Gigabit Ethernet 1/0/23]

A. IRF member ID B. IRF stack ID C. IRF master priority D. IRF port number

Correct Answer: A

Question 2

Refer to the exhibit below.
Which VLAN will be carried untagged on GigabitEthernet 2/0/2?

A. VLAN 102 B. VLAN 101 C. VLAN 1 D. VLAN 100

Correct Answer: A

Question 3

What is the VLAN membership of wireless traffic entering a switch from an HP E-MSM AP with default VLAN settings?

A. tagged VLAN 2100 B. tagged VLAN 192 C. untagged VLAN assigned by RADIUS profile D. untagged VLAN on a connected switch port

Correct Answer: D

Question 4

Which features of the HP E8200 zI switch series are not available on E-Series switches?
(Select Two)

A. support for 10Gig modules B. multiple firmware versions C. redundant switch fabric D. multiple configuration files E. redundant management modules

Correct Answer: C,E

Question 5

Which security technology requires that you set read/write community names?

A. SNMP B. SSH C. HTTPS D. SMTP E. SFTP

Correct Answer: A

Question 6

Which HP A-Series switch in an IRF stack will become Master if an election is required?

A. the switch with the longest uptime B. the switch that is the current Master C. the switch with the highest IRF Master priority D. the switch with the lowest bridge MAC address

Correct Answer: A

Question 7

You have configured Multiple Spanning Tree Protocol (MSTP) on two HP E8212 zl switches and four E5406 zl switches, but they have not joined the same MST region. Which configuration parameters should you verify to ensure all switches join the same region? (Select three)

A. configuration name B. BPDU Protection settings C. configuration revision D. VLAN-to-instance mappings E. port priorities F. bridge priorities

Correct Answer: A,C,D

Question 8

What is the default Spanning Tree Bridge Priority on an HP E3500 yI switch?

A. 32768 B. 1024 C. 4096 D. 0

Correct Answer: A

Question 9

Which command will configure an HP A-Series switch to be the Root Bridge in MST instance 1?

A. [Switch] spanning-tree instance 1 priority 0 B. [Switch] stp instance 1 priority root C. [switch] stp instance 1 root primary D. [Switch] mstp root instance 1

Correct Answer: C

Question 10

Which HP E-Series switch models display the following prompt in the interface configuration context? (Select two)
HP Switch (eth-A24)#

A. E8212zl B. E350CM8G-POEyI C. E2910-24Gal D. E6600-24G E. E5412-96GZI

Correct Answer: A,E

HP Network Infrastructure AIS 2011 - HP2-Z18 Exam Practice Test