HP2-Z34 Exam Training Practice Tests (HP Building HPE FlexFabric Data Centers)]

Question 1

Which statement is correct about a FibreChannel (FC) node-port (N-port) in a Storage Area Network (SAN) fabric topology?

A. It is a port on a SAN switch that connects to an initiator or target B. It is a port on a SAN switch that connects to a target but never to an initiator C. It is a port on an initiator or a target, and it connects to a fabric port (F-port) D. It is a port on an initiator but never a target, and it connects to an extension port (E-port).

Correct Answer: D

Question 2

What is an appropriate situation for configuring an interface as a silent TRILL access port?

A. The interface connects to a downstream non-TRILL switch, which is connected to another TRILL switch. The administrator does not want the interface to carry encapsulated TRILL traffic. B. The interface connects to a downstream non-TRILL switch, which is connected to another TRILL switch The administrator wants the interface to provide a backup path for encapsulated TRILL traffic C. The interface connects directly to server NICs. and it is a bridge aggregation on an IRF virtual device. D. The interface connects to another TRILL switch, which has a higher DRB priority than this switch

Correct Answer: D

Question 3

Refer to the exhibit

An administrator wants these switches to establish a TRILL region TRILL is enabled globally and nicknames are set. What must the administrator do so that each TRILL switch (RBridge) finds the best path to all other TRILL switches?

A. Create a Virtual Service Instance (VSI) on each switch and define the other switches as TRILL peers. B. Configure DRB priorities on all switch-to-switch links. C. Configure IS-IS on VLAN 1 on all the switches. D. Enable TRILL with the correct link-type on each switch-to-switch port

Correct Answer: D

Question 4

A company merger created a situation in which some network segments are using overlapping IP addresses. Administrators want to keep the overlapping addresses and isolate the segments. A core router connects to devices in both segments and routes some traffic for both.
What allows this router to route the traffic without conflict?

A. EVI B. Provider Backbone Bridging (PBB) C. VPLS D. Multi-VPN-Instance CE (MCE)

Correct Answer: D

Question 5

Refer to the exhibit

An MPLS Layer 2 VPN is being implemented between Sites 1 and 2. The administrator wants PE-1 and PE-2 to set up the Virtual Circuit (VC) dynamically by using the Martini method. What is required to accomplish this goal?

A. VPN instance with the same route distinguisher (RD) on PE-1 and PE-2 B. iPSec tunnel between PE-1 and PE-2 C. redistribution of Border Gateway Protocol (BGP) routes into Open Shortest Path First (OSPF) on PE-1 and PE-2 D. remote LDP session between PE-1 and PE-2

Correct Answer: A

Question 6

Refer to the exhibits Exhibit 1

This data center topology is being set up to use SPBM. VMs in the same subnet should be able to communicate at Layer 2 and be isolated at Layer 2 from other subnets. VS110010 was created for VLAN 10 as shown in Exhibit 2. The administrator is configuring a service instance for the VLAN 10 traffic on Switch 1 interface Ten1/0/1.
What is the correct encapsulation mode?

A. s-vid101 B. s-vid10 C. default D. ta99ed

Correct Answer: B

HP Building HPE FlexFabric Data Centers - HP2-Z34 Exam Practice Test