HPE0-S50 Exam Training Practice Tests (HP Integrating HPE Synergy Solutions)]

Question 1

Refer to the exhibit.

Based on the Synergy configuration shown, what will be the outcome in the event of an end-of-row (EoR) switch failure?

A. Uplink bandwidth will decrease. B. Smartlink will be triggered. C. There will be no NIC failover. D. Server and downlinks will fail.

Correct Answer: C

Question 2

A customer needs to expand a single-frame Synergy solution for two frames.
What should the synergy integrator do to establish a proper management network for the two frames?

A. In the Synergy Master console, select the Frame Link Modules in the new frame and define the connection between. B. Connect the RJ-45 front panel connectors on the two frames together with a single CAT6A cable. C. Connect the RJ-45 management ports of the Virtual Connect Modules together with redundant CAT6A cables. D. Disconnect the existing management ring and cable the Frame Link Modules in the first frame to the Frame Link Modules in the added frame.

Correct Answer: B

Question 3

Which utility compares currently running firmware with the upgrade firmware for the HPe Synergy FB Switch Module.
Which allows minimal downtime during the aggrade?

A. SMU B. SUM C. ISSU D. VCSU

Correct Answer: B

Question 4

Use the arrows or click and drag the HPE Synergy components on the left to their correct order firmware update, based on HPE best practices, on the right.

Correct Answer:

Explanation

References:https://support.hpe.com/hpsc/doc/public/display?docId=c05355899

Question 5

Use the arrow or click drag steps on the left to set up a new HPE Synergy 12000 Frame into the correct on the right.

Correct Answer:

Question 6

A customer is planning an HPE Synergy solution with 20 frames an needs to minimize the number of management ports that are required to connect the frames into the existing management network.
Which procedure should the Synergy into a integrator use to address the customer's concern?

A. Connect FLMs from all frames into a management ring: Then connect the management ring to the customer's management network using two uplinks. B. Connect FLMs from all frames to two external switches for redundancy: Then connect the two uplinks from the two switches into the customer management network. C. Connect the RJ-45 front ports of each frame to an external switch. Then connect the uplink from the external switch into the customer management network. D. Connect the RJ-45 front port of each frame to two external switches for redundancy: Then connect the uplink from the two switches into the customer's management network.

Correct Answer: A

HP Integrating HPE Synergy Solutions - HPE0-S50 Exam Practice Test