Juniper Junos Troubleshooting - JN0-691 Exam Practice Test

-- Exhibit --
[edit]
user@R1# run show interfaces ge-1/1/2 terse
Interface Admin Link Proto Local Remote
ge-1/1/2 up up
ge-1/1/2.0 up up aenet --> ae0.0
[edit]
user@R1# run show interfaces ge-1/1/3 terse
Interface Admin Link Proto Local Remote
ge-1/1/3 up up
ge-1/1/3.0 up up aenet --> ae0.0
[edit]
user@R1# run show interfaces ae0 terse
Interface Admin Link Proto Local Remote
ae0 up down
ae0.0 up down bridge
[edit]
user@R1# show interfaces ae0
aggregated-ether-options {
lacp {
periodic slow;
system-priority 200;
}
}
unit 0 {
family bridge {
interface-mode trunk;
vlan-id-list 100;
}
}
**************************************************************************
[edit]
user@R2# run show interfaces ge-1/1/2 terse
Interface Admin Link Proto Local Remote
ge-1/1/2 up up
ge-1/1/2.0 up up aenet --> ae0.0
[edit]
user@R2# run show interfaces ge-1/1/3 terse
Interface Admin Link Proto Local Remote
ge-1/1/3 up up
ge-1/1/3.0 up up aenet --> ae0.0
[edit]
user@R2# run show interfaces ae0 terse
Interface Admin Link Proto Local Remote
ae0 up down
ae0.0 up down bridge
[edit]
user@R2# show interfaces ae0
aggregated-ether-options {
lacp {
periodic fast;
system-priority 100;
}
}
unit 0 {
family bridge {
interface-mode trunk;
vlan-id-list 100;
}
}
-- Exhibit --
You have configured a LAG and are now enabling LACP on the ae0 interface. You have configured and committed the configuration as shown in the exhibit. However, the exhibit also shows that the ae0 interface is now in the up/down state.
What must you do to resolve this problem?

You are troubleshooting an EBGP peering that is not establishing between loopback addresses.
In this scenario, which two statements are correct? (Choose two.)

Which process is responsible for replicating information between Routing Engines running GRES?

To protect theRouting Engine of your Junos device from denial-of-service attacks, you created a firewall filter.
Where do you apply the firewall filter?

Which three commands will provide details about CPU utilization on a line card? (Choose three.)

Click the Exhibit button.
-- Exhibit -=================== Bootstrap installer starting =================== Initialized the environment Routing engine model is RE-S-1800x4 Discovered that flash disk = ad0 , hard disk = ad1 mount: /dev/ad1s1f : Invalid argument ERROR: mount_partition: Mount /dev/ad1s1a /mnt failed You are now in a debugging subshell (you may not see a prompt)... # -- Exhibit -
During the boot of your MX480, you see the output shown in the exhibit. Which three statements are true? (Choose three.)