NSE6_FSW-7.2 Exam Training Practice Tests (Fortinet NSE 6

Question 1

Exhibit.

Two routes are not installed in the forwarding information base (FIB) as shown in the exnibit. Which two statements about these two route entries are true? (Choose two.)

A. These two routes will be used as load-balancing routes. B. These two routes have a higher administrative distance value available to the destination networks. C. These two routes are available in the hardware routing table. D. These two routes will become primary, if the best routes are removed.

Correct Answer: B,D

Explanation: Only visible for TrainingDump members. You can sign-up / login (it's free).

Question 2

Which drop policy mode, if assigned to a congested port, will drop incoming packets until there is no congestion on the egress port?

A. Strict mode B. Weighted round robin mode. C. Tail-drop mode D. Random early detection mode

Correct Answer: C

Explanation: Only visible for TrainingDump members. You can sign-up / login (it's free).

Question 3

Refer to the diagnostic output:

Two entries in the exhibit show that the same MAC address has been used in two different VLANs. Which MAC address is shown in the above output?

A. It is a MAC address of a switch that accepts multiple VLANs. B. It is a MAC address of FortiGate in HA configuration. C. It is a MAC address of an upstream FortiSwitch. D. It is a MAC address of FortiLink interface on FortiGate.

Correct Answer: A

Explanation: Only visible for TrainingDump members. You can sign-up / login (it's free).

Question 4

Which statement about the IGMP snooping querier when enabled on a VLAN is true?

A. IGMP reports on the VLAN are forwarded to all switch ports. B. All other indirectly connected switches will be unable to get IGMP multicast traffic. C. Active multicast receiver entries are aging on each IGMP query sent on the VLAN D. The setting can only be enabled using the FortiSwitch CLI.

Correct Answer: C

Explanation: Only visible for TrainingDump members. You can sign-up / login (it's free).

Question 5

Exhibit.

You need to manage three FortiSwitch devices using a FortiGate device. Two of the FortiSwitch devices initiated a reboot after the authorization process. However, the FortiSwitch device with the configuration shown in the exhibit. did not reboot All three devices completed FortiLink manage-ment authorization successfully.
Why did the FortiSwitch device shown in the exhibit not reboot to complete the authorization pro-cess?
The management mode was set to use FortiLink mode.

A. The FortiSwitch device is scheduled to reboot as part the authorization process B. Switch auto-discovery is enabled. C. The management mode was set to use FortiLink mode. D. The system time is not in-sync and is using a non-default value

Correct Answer: C

Explanation: Only visible for TrainingDump members. You can sign-up / login (it's free).

Question 6

What feature can network administrators use to segment network operations and the administration of managed FortiSwitch devices on FortiGate?

A. FortiGate clustering protocol B. Multi-chassis link aggregation trunk C. FortiGate multi-tenancy D. FortiLink split interface

Correct Answer: C

Explanation: Only visible for TrainingDump members. You can sign-up / login (it's free).

Fortinet NSE 6 - FortiSwitch 7.2 - NSE6_FSW-7.2 Exam Practice Test