2024 Current CWDP-304 dumps Preparation through Our Practice Test
100% Reliable Microsoft CWDP-304 Exam Dumps Test Pdf Exam Material
NEW QUESTION # 66
When designing a WLAN to support voice in a large office, which design element is of the highest concern for performance?
- A. Band steering
- B. AP vendor
- C. Roaming
- D. Frequency Selection
Answer: C
NEW QUESTION # 67
What might limit the ability to locate 802.11 clients using a WLAN infrastructure without an 802.11 tag?
- A. When it is off
- B. Lack of 802.11k support
- C. When its radio is disabled
- D. When its radio is disabled
Answer: A
NEW QUESTION # 68
Which DHCP option, when required, should be configured and enabled to help APs locate their wireless LAN controller?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
NEW QUESTION # 69
Modulation can be defined as:
Response:
- A. The process of representing data using RF coding
- B. The process of modifying a carrier signal to represent data
- C. The process of incorporating a chipping code to build resilience
- D. The process of encoding data symbols using a carrier frequency
Answer: B
NEW QUESTION # 70
When you see the SKINNY protocol in a post-install validation protocol capture, what does this indicate?
- A. VoIP is used on the network
- B. HTTPS is in use
- C. Multicasting is used on the network
- D. Secure FTP is in use
Answer: A
NEW QUESTION # 71
When you see the SKINNY protocol in a post-install validation protocol capture, what does this indicate?
Response:
- A. VoIP is used on the network
- B. HTTPS is in use
- C. Multicasting is used on the network
- D. Secure FTP is in use
Answer: A
NEW QUESTION # 72
You deployed an AP and installed its antenna, and you now need to set the AP transmit power. Given a desired EIRP of 21 dBm, and an antenna gain of 5.85 dBd connected through 25 feet of cable with a loss specification of 4 dB/100 feet.
Assuming that there is no significant loss from the connectors, what should be the transmit power level for this AP?
- A. 25 mW
- B. 20 mW
- C. 10 mW
- D. 14 mW
Answer: A
NEW QUESTION # 73
A wireless network with fewer APs at higher power levels to cover a large area is said to be which of the following?
Response:
- A. Destined for failure
- B. Ideal for roaming
- C. Coverage based
- D. Capacity based
Answer: C
NEW QUESTION # 74
What document should be created that provides instructions for install technicians to mount and configure APs?
- A. Statement of Work
- B. Bill of Materials
- C. Physical installation guide
- D. Hold Harmless
Answer: C
NEW QUESTION # 75
A museum wants to offer Wi-Fi to its visitors. One of their requirements is to have the APs blend into the design of the museum. What should you do to meet this requirement?
Response:
- A. Use a plastic cover that could blend in with the environment
- B. Place the APs in between walls and I-beams
- C. Lock the AP inside of a metal box
- D. Use an 802.11b AP, so it looks old enough to be in a museum
Answer: A
NEW QUESTION # 76
In an RSN requiring low-latency reassociations and no fast secure roaming protocols, what security solutions are ideal for protecting VoWiFi communication?(Choose all that apply.) Response:
- A. WEP
- B. WPA-Personal
- C. WPA2-Personal
- D. WPA2-Enterprise
- E. 802.1X/EAP
Answer: C,D
Explanation:
WPA2-Personal and WPA2-Enterprise are ideal security solutions for protecting VoWiFi communication in an RSN requiring low-latency reassociations and no fast secure roaming protocols. WPA2-Personal uses a pre-shared key (PSK) to authenticate and encrypt the communication between the VoWiFi device and the access point. WPA2-Enterprise uses 802.1X/EAP to authenticate the VoWiFi device and the RADIUS server, and then derives a unique encryption key for each session. Both WPA2-Personal and WPA2-Enterprise use AES-CCMP as the encryption algorithm, which provides strong security and low overhead. WPA2-Personal and WPA2-Enterprise also support key caching andpre-authentication mechanisms, which reduce the latency and disruption during reassociations. These features are essential for maintaining the quality of service and user experience for VoWiFi communication.
WPA-Personal, WEP, and 802.1X/EAP are not ideal security solutions for protecting VoWiFi communication in an RSN requiring low-latency reassociations and no fast secure roaming protocols. WPA-Personal uses TKIP as the encryption algorithm, which is less secure and more computationally intensive than AES-CCMP.
WPA-Personal also does not support key caching and pre-authentication mechanisms, which increase the latency and disruption during reassociations. WEP is an outdated and insecure encryption algorithm that can be easily cracked by attackers. WEP also does not support any authentication or key management mechanisms, which expose the VoWiFi communication to various attacks. 802.1X/EAP is an authentication framework, not a security solution. 802.1X/EAP alone does not provide any encryption or key management for the VoWiFi communication. 802.1X/EAP must be combined with a robust encryption algorithm, such as AES-CCMP, to provide adequate security for VoWiFi communication. References: CWNP, CWDP Certified Wireless Design Professional Official Study Guide, Security Considerations for Voice over Wi-Fi (VoWiFi) Systems, Top 13 VoIP Security Issues and How to Combat Them
NEW QUESTION # 77
You desire to achieve a 450 Mbps MCS. What 802.11n features (from the numbered list below) are required?
1. Frame aggregation
2. Short GI
3. 40 MHz channels
4. 2 spatial streams
5. 3 spatial streams
6. Transmit beamforming (TxBF)
- A. 2, 3, 2
- B. 1, 2, 3, 4, 6
- C. 1, 2, 3, 5
- D. 2, 3, 5
Answer: D
NEW QUESTION # 78
What factors are key features when designing a guest network for a large enterprise?(Choose all that apply.) Response:
- A. SSID segmentation
- B. Rate limiting
- C. 802.1X security
- D. Traffic tunneling or anchoring
- E. 802.11n
Answer: B,D
NEW QUESTION # 79
What are methods of providing RF high availability?
Response:
- A. Use the HSRP/VRRP protocol.
- B. Deploy using 100 percent overlap.
- C. Deploy 802.3af.
- D. Use dual spectrums.
- E. Power APs to maximum power.
Answer: B
NEW QUESTION # 80
A bandpass filter has a maximum in-band loss of 1.5 dB, ripple of 0.4 dB, and a return loss of 15 dB. What is the minimum in-band loss?
Response:
- A. 1.9 dB
- B. 1.5 dB
- C. 1.1 dB
- D. 13.5 dB
Answer: C
NEW QUESTION # 81
For what types of systems should you request read-only access to in order to perform an analysis of the customer's existing infrastructure?(Choose all that apply.) Response:
- A. RADIUS
- B. Routers
- C. Routers Directory
- D. Switches
- E. Clients
- F. Active Directory
Answer: B,D
NEW QUESTION # 82
Given: For this fill-in the blank question, each answer option contains an answer for the first and second blanks, separated by a dash "-". Choose the answer option that correctly fills in both blanks in the following sentence.
A WLAN may use 802.11 admission control to ________, and admission control requirements are configured separately for each ________.
- A. Regulate the available bandwidth resources - Access Category
- B. Mark ingress and egress frames with priority values - TCP/IP port
- C. Identify voice-enabled wireless devices - AP radio (that is, 2.4 GHz or 5 GHz)
- D. Block stations with inadequate security parameters - SSID
Answer: A
NEW QUESTION # 83
During an RFP analysis, one of the vendors mentioned that you'll need to upgrade your Gigabit Ethernet switches to MultiGig switches to ensure support for
802.11ac and 802.11ax, which both offer data rates over 1Gbps. Why is this not sound advice?
- A. Because neither of the technologies support data rates over 1Gbps
- B. Because 802.11ac only supports one spatial stream
- C. Because 802.11ax doesn't support channel bonding
- D. Management overhead that is normal in WLANs will reduce the throughput of the client devices
Answer: D
NEW QUESTION # 84
Which of the following items could be considered constraints when performing a network design?(Choose all that apply.)
- A. Personnel
- B. Budget
- C. Timeline
- D. Politics
Answer: A,B,C,D
NEW QUESTION # 85
Looking at a client radio specification sheet that states Receive Sensitivity of 82 dBm @ 18 Mbps would mean:
Response:
- A. It must hear a signal <82 dBm in order to demodulate the 18 Mbps PHY rate.
- B. It would need to hear a signal <82 dBm in order to use the 24 Mbps PHY rate.
- C. It is only capable of transmitting at 18 Mbps PHY rates at 82 dBm.
- D. It must hear a signal >82 dBm in order to demodulate the 18 Mbps PHY rate.
Answer: A
NEW QUESTION # 86
Prior to meeting with the customer for the first time, you should do which of the following?
Response:
- A. Find out what vendor their competitors use.
- B. Plan an initial design to present to them.
- C. Decide which vendor they will benefit most from.
- D. Research the customer as much as possible. Try to understand what their business is, who their customers are, and any other information you can find regarding product lines and recent press announcements.
Answer: D
NEW QUESTION # 87
What type of standards-based encryption is used by office extension APs for the traffic tunnel?(Choose all that apply.) Response:
- A. CAPWAP
- B. DTLS
- C. LWAPP
- D. TKIP
- E. AES
Answer: A,B
Explanation:
CAPWAP and DTLS are the type of standards-based encryption used by office extension APs for the traffic tunnel. Office extension APs are wireless access points that can be deployed in remote locations and connect to a central wireless controller via a secure tunnel over the Internet. CAPWAP is the Control and Provisioning of Wireless Access Points protocol, which defines how the wireless controller and the office extension APs communicate and exchange control and data messages. DTLS is the Datagram Transport Layer Security protocol, which provides encryption and authentication for the CAPWAP tunnel. DTLS is based on TLS, but it uses UDP instead of TCP as the transport layer protocol, which makes it more suitable for real-time applications. DTLS protects the CAPWAP tunnel from eavesdropping, tampering, and replay attacks, and ensures the confidentiality and integrity of the wireless traffic. References: CWNP, CWDP Certified Wireless Design Professional Official Study Guide, Configure OEAP and RLAN on Catalyst 9800 WLC, Hardening Microsoft 365, Office 2021, Office 2019 and Office 2016
NEW QUESTION # 88
......
CWNP CWDP-304 Exam Topics:
| Section | Objectives |
|---|---|
Define Specifications for the WLAN - 25% | |
| Collect business requirements and constraints | - Business use cases and justification - User requirements - Regulatory compliance - Industry compliance - Budget - Aesthetics - Architectural constraints - Mounting restrictions - Access restrictions - Time constraints - Building codes and safety codes |
| Collect and define technical requirements | - Vendor selection - Location services such as RTLS - Latency requirements - Signal strength requirements - Capacity requirements - Security requirements
- Applications and their specific requirements |
| Collect project documentation | - Validated floor plans - Network infrastructure
- Cabling infrastructure
- Power availability and PoE capabilities |
| Define requirement areas including essential metrics for each requirement | - Client device types and capabilities - Applications and their requirements - User and device density - SSIDs - Security settings - Understand common vertical markets |
| Gather information on environmental factors | - Building materials - Attenuation values - Ceiling heights - Site annotations (photos, notes, plans) - Wireless environment scan
|
Design the WLAN - 40% | |
| Define WLAN architectures and select the appropriate architecture for a design | - Controller-based (physical and virtual) architectures - Distributed (cloud-based and local WNMS) - Standalone/Autonomous APs - Dynamic vs. static channel assignment - Dynamic radio management - Software defined radios - RF profiles - Select and/or recommend the appropriate equipment for the design and selected architecture (APs, antennas, controllers, managed services) |
| Produce a design to meet requirements | - Select and use the appropriate design tools
- Select and use the appropriate design methodologies
- Understand and use the common features of wireless design software
- Select and use common vendor features and make configuration recommendations
- Design for different client and application types
- Ensure end-to-end QoS is properly implemented
- Define and recommend security solutions
- Design for secure roaming
|
| Create, distributed, and communicate design documentation | - Bill of Materials (BoM) - Design reports - Physical installation guide |
Deploy the WLAN - 10% | |
| Ensure proper understanding and implementation of the design | - Implementation meeting
- Distribute required documentation |
| Recommend or perform essential deployment tasks | - Understand and perform installation procedures for different WLAN architectures (cloud-based, controller-based, WNMS, autonomous) - Infrastructure configuration supporting the WLAN (DHCP, DNS, NTP, switches, and routers) - Channel assignment, automatic radio management, and transmit power configuration - Installation procedures for cloud-based APs, controller-based APs, WNMS APs, and autonomous APs |
CWNP CWDP-304 Exam Certification Details:
| Sample Questions | CWNP CWDP-304 Sample Questions |
| Recommended Training | CWDP self-paced training kit, Live Wi-Fi Design Training Class |
| Duration | 90 minutes |
| Exam Price | $275 USD |
| Passing Score | 70% |
Free CWDP-304 Dumps are Available for Instant Access: https://www.trainingdump.com/CWNP/CWDP-304-practice-exam-dumps.html
Based on Official Syllabus Topics of Actual CWNP CWDP-304 Exam: https://drive.google.com/open?id=13QbgoIu9pXBOx0AMNwXXX2GHO0QiN5mA