Pass NCSC-Level-1 Exam - Real Test Engine PDF with 80 Questions
Get New NCSC-Level-1 Certification Practice Test Questions Exam Dumps
NEW QUESTION 40
A consultant is planning a new cluster installation and needs to locate the Shared IPMI port for each of the specific nodes that the customer has bought.
Which Support Portal location contains the document that would identify the port?
- A. Knowledge Base
- B. Hardware Replacement Documentation
- C. Solutions Documentation
- D. Software Documentation
Answer: B
NEW QUESTION 41
In a 20-node ESXi deployment, the customer needs additional resiliency to survive the loss of two nodes concurrently.
Which configuration should the consultant use to ensure that the appropriate resources are available?
- A. Storage reservation for 10%; HA admission control for 10%, cluster RF2
- B. Storage reservation for 5%; HA admission control for 5%, cluster RF3
- C. Storage reservation for 10%; HA admission control for 10%, cluster RF3
- D. Storage reservation for 5%; HA admission control for 5%, cluster RF2
Answer: C
NEW QUESTION 42
A customer needs to meet the following requirements for their business critical application:
* SQL Servers must be on specific hosts to lower licensing costs.
* Oracle RAC servers must be on separate hosts for licensing reasons
Which policy or policies should be implemented to meet these requirements?
- A. Configure VM-VM affinity policy.
- B. Configure VM-VM anti-affinity policy.
- C. Configure both VM-Host and VM-VM affinity policy.
- D. Configure VM-Host affinity policy.
Answer: D
NEW QUESTION 43
A customer would like to re-image an existing cluster. The Foundation Applet and Foundation VM is unavailable to them.
How can the consultant access Foundation-as-a-Service (FaaS)?
- A. Through <cluster-IP> :8000
- B. Through <CVM-IP> :8000
- C. Through <cluster-IP> :9443
- D. Through <CVM-IP> :9443
Answer: B
NEW QUESTION 44
A consultant configures a Nutanix cluster and integrates the hosts into vCenter using VMware best practices. The customer has requested that the Nutanix cluster only have a single datastore.
Upon configuring the cluster per the customer requirements, vCenter displays an alert regarding the heartbeat datastore. The consultant adds the das.ignoreInsufficientHbDatastore value = true rule. The container can be seen from each host, but the alert remains active.
What should the consultant do to resolve this issue?
- A. Turn off and then turn back on HA.
- B. Whitelist the vCenter IP address within Prism.
- C. Make sure the DRS setting is turned on.
- D. Create a second container.
Answer: A
NEW QUESTION 45
A consultant is viewing an ESXi host via console without external network connectivity.
Which two IP addresses can be used to connect to the CVM (Choose two.)
- A. 192.168.5.254
- B. 192.168.5.253
- C. 192.168.5.2
- D. 192.168.5.1
Answer: A,C
NEW QUESTION 46
What is the minimum number of nodes required for a Nutanix Cluster to support Replication Factor 3 (RF3) on a storage container?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION 47
Which subnet is reserved for internal connectivity within a Nutanix Cluster?
- A. 192.168.5.0/26
- B. 192.168.5.0/23
- C. 192.168.5.0/24
- D. 192.168.254.0/24
Answer: C
NEW QUESTION 48
A consultant creates a new cluster using ESXi as the hypervisor. After creating the cluster, the consultant begins to run Life Cycle Manager (LCM) updates. During the LCM upgrade pre-checks, an error is returned.
Which configuration is causing this issue?
- A. ESXi cluster admission control is disabled.
- B. ESXi cluster DRS is enabled.
- C. ESXi cluster admission control is enabled.
- D. ESXi cluster HA is enabled.
Answer: C
NEW QUESTION 49
After a consultant runs Foundation, the imaging process fails.
In which two locations can the consultant find the logs? (Choose two.)
- A. Logs link on the Foundation Imaging Screen
- B. On the Foundation VM - /home/nutanix/foundation/logs
- C. On the Hypervisor - /home/nutanix/foundation/logs
- D. On the CVM - /home/Nutanix/foundation/logs
Answer: A,B
NEW QUESTION 50
A consultant notices while assigning VLAN tags to hosts and CVMs in a running cluster, that Prism Element displays alerts indicating a node is down.
What should the consultant do to prevent these alerts?
- A. Stop the Nutanix cluster before changing VLANs.
- B. Only change the hypervisor VLANs.
- C. Restart the Nutanix cluster.
- D. Only change the Controller Virtual Machine VLANs.
Answer: A
NEW QUESTION 51
For a new AHV cluster installation, a customer has 20 NX-8155-G6 nodes with quad port SFP NICs.
The customer wants to meet the following guidelines:
* Take advantage of all available 10GbE links
* Achieve maximum throughput per VM
* Use of redundant ToR switches
* Fastest reconvergence during link failure
How should the load balancing be configured on the host?
- A. ovs-vsctl set port br0-up other_config:lacp-fallback-ab=true
ovs-vsctl set port br0-up lacp=active
ovs-vsctl set port br0-up bond_mode=balance-tcp - B. ovs-vsctl set port br0-up bond_mode=balance-slb
ovs-vsctl set port br0-up other_config:bond-rebalance-interval=30000
ovs-vsctl set port br0 tag=10 - C. ovs-vsctl set port br0-up bond_mode=balance-slb
- D. ovs-vsctl set port br0-up bond_mode=active-backup
ovs-vsctl set port br0-up other_config:bond-rebalance-interval=30000
Answer: B
NEW QUESTION 52
Refer to the exhibits.
A consultant is trying to test port failover on the node shown in the first exhibit. A continuous ping test is performed to the host. The consultant shuts down one of the links, after which the host ping request times out. The consultant tries to troubleshoot the issue with the customer and sees the information shown in the second exhibit on their Cisco Switches:
What is causing the issue?
- A. The wrong VLAN is tagged on the host.
- B. PortFast is not enabled on the port connected to the host.
- C. Bad SPF+ cables are on the active interface.
- D. There is a Native VLAN mismatch on the switchport.
Answer: D
NEW QUESTION 53
A consultant is installing Nutanix AOS on Cisco UCS.
Which method should be used to install AOS on UCS hardware platforms?
- A. Foundation as a Service
- B. Foundation Applet
- C. Foundation VM
- D. Foundation Central
Answer: C
NEW QUESTION 54
An existing Nutanix customer has several clusters in production and is adding a new cluster. The customer wants to create an AHV cluster that has already been racked and powered on remotely, with the factory image, using Prism Central.
Which step should the consultant take next?
- A. Build the cluster with the Foundation Applet
- B. Build the cluster with the Foundation VM.
- C. Build the cluster with Foundation Central.
- D. Bare metal image the nodes with the Foundation VM.
Answer: A
NEW QUESTION 55
Which two components must be identified to validate that software compatibility requirements are met for Nutanix Cluster Installation? (Choose two.)
- A. AOS
- B. Guest OS
- C. Firmware
- D. Hypervisor
Answer: A,D
NEW QUESTION 56
A consultant is setting up a new vSphere cluster. Customer requirements are as follows:
* VMs should automatically failover to another host if the host crashes
* Host CPU and Memory resources should be evenly balanced
* New VMs should be placed on the host with the most resources available Which two settings should be turned on to meet the requirements? (Choose two.)
- A. vSphere vMotion
- B. vShpere DRS
- C. vSphere Power Management
- D. vSphere HA
Answer: B,D
NEW QUESTION 57
A consultant is deploying a Nutanix cluster at a customer location. The consultant will be deploying the latest AOS along with the latest Nutanix hardware.
Which three references should the consultant review prior to this installation? (Choose three.)
- A. Software Product Interoperability
- B. Field & Security Advisories
- C. Acropolis Advanced Administration Guide
- D. End-Of-Life (EOL) Information
- E. Release Notes
Answer: A,B,E
NEW QUESTION 58
A consultant creates an AHV cluster and connects the Intel X550T NICs to the top of rack switch using Twinax cables. The activity and link lights are green. The cluster cannot communicate over the 10GbE link.
What is the first command the consultant should perform to troubleshoot the issue?
- A. manage_ovs update_uplinks
- B. manage_ovs show_bridges
- C. manage_ovs show_uplinks
- D. manage_ovs show_interfaces
Answer: B
NEW QUESTION 59
After finishing foundation on an AHV cluster, a consultant is preparing to plug into the customer network given the following set of requirements:
* All network traffic on trunks is tagged
* Customer is using LACP
* A native VLAN is not in use
Which set of commands should the consultant use to ensure cluster connectivity on customer equipment?
- A. change_cvm_vlan 10
ovs-vsctl set port br0 tag=10
ovs-vsctl set port br0-up bond_mode=balance-tcp - B. change_cvm_vlan 0
ovs-vsctl set port br0 tag=0
ovs-vsctl set port br0-up bond_mode=balance-tcp - C. change_cvm_vlan 0
ovs~vsctl set port br0 tag=0
ovs~vsctl set port br0-up bond_mode=active-backup - D. change_cvm_vlan 10
ovs-vsctl set port br0 tag=10
ovs-vsctl set port br0-up bond_mode=balance-slb
Answer: B
NEW QUESTION 60
Where can a consultant find Nutanix Enablement Starter Packs (ESPs)?
- A. In the Services section of the Nutanix website.
- B. In the Nutanix .NEXT Community Forum
- C. In the Support Portal
- D. In the Partner Portal
Answer: D
NEW QUESTION 61
A consultant successfully completes a Foundation using a flat switch. The consultant then works with the customer to move the cluster over to their production network. After the move, the CVMs and hypervisors can no longer communicate, which prevents the cluster from starting.
Which option should be used to resolve this issue?
- A. If the IPMI is in use, check that the IPMI can ping the default gateway over IPv6.
- B. Make sure that the IPMI and CVM VLAN is manually tagged on the Host and CVM.
- C. If using VLANs, confirm the hypervisor/CVM VLAN is set as Native on the switch ports.
- D. Verify that IPv6 Link Local and DHCP is enabled on all switch ports.
Answer: C
NEW QUESTION 62
A consultant is unable to install virtualization software on a laptop.
Which two versions of Foundation can be used to resolve this issue? (Choose two.)
- A. Foundation VM
- B. Foundation Applet
- C. Foundation Central
- D. Foundation Portable
Answer: B,D
NEW QUESTION 63
......
NCSC-Level-1 Exam Dumps - PDF Questions and Testing Engine: https://www.trainingdump.com/Nutanix/NCSC-Level-1-practice-exam-dumps.html