A fully updated 2021 DES-1221 Exam Dumps exam guide from training expert TrainingDump
Provides complete coverage of every objective on exam and exam preparation DES-1221
NEW QUESTION 28
Refer to the Exhibit.
Note the yellow arrow. A Data Center Engineer notices that the LED is blinking blue and amber alternating at one second intervals. What does this indicate?
- A. System not initialized
- B. Node is Degraded
- C. System is booting
- D. Node in Service Mode
Answer: D
NEW QUESTION 29
What is the significance of the warning given when a volume with data services is deleted?
- A. Protection policy is configured on the volume
- B. Snapshot is present on the volume
- C. Volume is participating in a migration
- D. Volume is mapped to a host
Answer: B
Explanation:
Reference: https://www.dell.com/support/manuals/en-pk/powerstore/pwrstr-cfg-vols/delete-a-volume?
guid=guid-26e8c12d-a3df-4d4d-8012-ae2ef9e53721&lang=en-us
NEW QUESTION 30
Refer to the Exhibit.
A Network administrator is failing to discover a PowerStore T system using the PowerStore Discovery Utility. What might be the issue?
- A. Port 54 has not been set to trunk mode
- B. Discovery network uses only native VLAN
- C. Port 54 needs to be enabled
- D. Dedicated port needs to be used for discovery network
Answer: B
NEW QUESTION 31
A storage administrator has provisioned 10 * 2GB volumes. 400MB of data is written to each of the ten volumes. What is the Thin Savings ratio for this configuration?
- A. 4:1
- B. 5:1
- C. 3:1
- D. 6:1
Answer: B
NEW QUESTION 32
A storage administrator has provisioned a 50GB volume and presented it to an application. The application owner has requested that the volume be replicated to a secondary array. Which policy should be assigned to the volume to enable replication?
- A. Performance
- B. Remote
- C. Protection
- D. Replication
Answer: D
NEW QUESTION 33
How many cables are required for minimum support for PowerStore T Front-End storage connectivity?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
Explanation:
NEW QUESTION 34
A SQL Cluster with attached PowerStore storage has Volumes SQL1, SQL2, SQL4, SQL5 which all require write order preservation. The SQL administrator no longer requires SQL4 and has removed it from the database. The Storage Administrator goes to delete volume SQL4 and finds that the option is grayed out.
Why is the option to delete the volume unavailable?
- A. SQL4 is part of a volume group
- B. SQL4 still has snapshots
- C. SQL4 still has replications
- D. SQL4 was renamed from SQL3
Answer: A
NEW QUESTION 35
A PowerStore T administrator discovers that only one port on each node is active and passing traffic. The other port is healthy and online, but total bandwidth is only half of what the customer expects. Which action could resolve the issue?
- A. Configure Link Aggregation Control Protocol and Dynamic Link Aggregation Group
- B. Configure VLT and Link Aggregation Control Protocol
- C. Implement Dynamic Link Aggregation Group
- D. Implement VLT and Dynamic Link Aggregation Group
Answer: B
Explanation:
Reference: https://www.delltechnologies.com/resources/en-us/asset/white-papers/products/storage/h18157- dell-emc-powerstore-clustering-high-availability.pdf
NEW QUESTION 36
What is the correct power up sequence for a PowerStore?
- A. 1. Expansion Enclosure, 2. Base Enclosure
- B. 1. Base Enclosure Node B, 2. Base Enclosure Node A, 3. Expansion Enclosure
- C. 1. Base Enclosure, 2. Expansion Enclosure
- D. 1. Base Enclosure Node A, 2. Base Enclosure Node B, 3. Expansion Enclosure
Answer: C
NEW QUESTION 37
What describes the remote replication Failover operation?
- A. It is run automatically by the replication destination system in the event of a source system outage
- B. It is run from the replication destination system by the administrator in the event of a source system outage
- C. It is run automatically by the replication source system in the event of a source system outage
- D. It is run from the replication source system by the administrator in the event of an outage on the system
Answer: B
NEW QUESTION 38
An administrator receives an alert on a PowerStore Cluster with three appliances:
The appliance A1 is projected to run out of space in 8 days
Capacity utilization is above 90 percent
Which tools are available to assist the Administrator with a potential resolution?
- A. Space reclamation wizard
- B. Thin provision conversion wizard
- C. Assisted Migration
- D. System Optimization
Answer: C
Explanation:
Explanation/Reference:
Reference: https://volumes.blog/2020/05/18/what-is-powerstore-part-11-resource-balancer/
NEW QUESTION 39
What is the correct power up sequence for a PowerStore?
- A. 1. Base Enclosure Node B, 2. Base Enclosure Node A, 3. Expansion Enclosure
- B. 1. Base Enclosure, 2. Expansion Enclosure
- C. 1. Expansion Enclosure, 2. Base Enclosure
- D. 1. Base Enclosure Node A, 2. Base Enclosure Node B, 3. Expansion Enclosure
Answer: C
NEW QUESTION 40
Match the correct Base Enclosure port in column A to the Expansion Enclosure port in column B to show the correct cabling for adding a single expansion enclosure to a base enclosure.
Answer:
Explanation:
Reference:
https://www.dell.com/support/manuals/en-pk/powerstore/pwrstr-isg/cable-the-base-enclosure-to-the-expansion-enclosure?guid=guid-d68d049f-2b77-489f-b1ab-553f4f3de8aa&lang=en-us
NEW QUESTION 41
A protection policy with snapshot and replication rules is applied to a file system. What is the result?
- A. Snapshot rules get ignored and only replication rules get applied
- B. Replication rules get ignored and only snapshot rules get applied
- C. Applying the protection policy to the file system fails
- D. Both replication and snapshot rules get applied
Answer: D
Explanation:
Explanation/Reference: https://www.dell.com/support/manuals/en-pk/powerstore/pwrstr-protect-data/data-protection-in- powerstore?guid=guid-19c6d0e1-fa20-4fb5-9983-61c17abaf21b&lang=en-us
NEW QUESTION 42
Refer to the Exhibit.
A Network administrator is failing to discover a PowerStore T system using the PowerStore Discovery Utility. What might be the issue?
- A. Dedicated port needs to be used for discovery network
- B. Port 54 has not been set to trunk mode
- C. Discovery network uses only native VLAN
- D. Port 54 needs to be enabled
Answer: A
NEW QUESTION 43
An administrator has performed the Cutover operation for an import session from a VNX2 source storage system.
What is a result of the operation?
- A. Imported LUN is removed from the VNX2 Storage Group
- B. Storage Group containing the imported LUN is deleted
- C. Host is removed from the VNX2 Storage Group
- D. Imported LUN is deleted from the VNX2
Answer: A
Explanation:
Explanation/Reference: https://laptrinhx.com/what-is-dell-emc-powerstore-part-7-importing-external-storage-
146661351/
NEW QUESTION 44
What is a way to verify the data path connectivity between a source VNX2 storage system and the PowerStore system when configuring an import session?
- A. Verify host initiators on PowerStore Manager
- B. Use the VNX2 SP ping operation
- C. Examine Fibre Channel zoning
- D. Review Server Manager MPIO properties
Answer: B
NEW QUESTION 45
While configuring a Dell switch with PowerStore, what are the recommended license outputs from a show license status command?
- A. Type: Perpetual, Status: Active
- B. Type: Term-Based, Status: Active
- C. Status: Perpetual, Type: Open
- D. Status: Term-Based, Type: Unlimited
Answer: A
Explanation:
Explanation/Reference: https://www.dell.com/support/manuals/en-pk/powerstore/pwrstr-ntwk-cfg/validate-the-top-of- rack-tor-switch-versions-and-licensing?guid=guid-40c30b91-7fb2-4a26-bac7-4ae67c07bdfb&lang=en-us
NEW QUESTION 46
In a PowerStore T source cluster, create a 100GB volume with name "Prod_vol" and set a protection policy to replicate the volume with RPO 30 minutes to a destination cluster. The destination cluster is already configured. When you have finished using the simulator, click Next.
Answer:
Explanation:
Below are the exhibits solution for this simulation.















NEW QUESTION 47
What is the final configuration step when installing the ImportKit for a Windows host accessing VNX2 storage?
- A. Configure the network port and interface for the management control path
- B. Select the RSA key for configuring the control path HTTPS certificate
- C. Select the folder location on the host for the program installation
- D. Configure the network port and interface for the host data path
Answer: A
NEW QUESTION 48
A storage administrator has provisioned a 50GB volume and presented it to an application. The application owner has requested that the volume be replicated to a secondary array. Which policy should be assigned to the volume to enable replication?
- A. Performance
- B. Remote
- C. Replication
- D. Protection
Answer: D
NEW QUESTION 49
......
Tested Material Used To DES-1221: https://www.trainingdump.com/EMC/DES-1221-practice-exam-dumps.html
Steps Necessary To Pass The DES-1221 Exam: https://drive.google.com/open?id=1SzUWBKLcx8XW6qSqcUNSkzmhFCZAjq_V