Pass Fortinet NSE7_SDW-7.0 Exam With Practice Test Questions Dumps Bundle
2024 Valid NSE7_SDW-7.0 test answers & Fortinet Exam PDF
To become certified in Fortinet NSE7_SDW-7.0, candidates must pass a rigorous certification exam. NSE7_SDW-7.0 exam consists of multiple-choice questions, and the candidate must score at least 70% to pass the exam. NSE7_SDW-7.0 exam can be taken at any Pearson VUE testing center worldwide.
NEW QUESTION # 38
Refer to the exhibit.
Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?
- A. The type of traffic defined and allowed on firewall policy ID 1 is UDP.
- B. Firewall policy ID 1 has source NAT disabled.
- C. FortiGate has terminated the session after a change on policy ID 1.
- D. Changes have been made on firewall policy ID 1 on FortiGate.
Answer: D
NEW QUESTION # 39
Which two statements about the SD-WAN zone configuration are true? (Choose two.)
- A. The default zones are virtual-wan-link and SASE.
- B. The service-sla-tie-break setting enables you to configure preferred member selection based on the best route to the destination.
- C. An SD-WAN member can belong to two or more zones.
- D. You can delete the default zones.
Answer: A,B
NEW QUESTION # 40
Refer to the exhibit.
FortiGate has multiple dial-up VPN interfaces incoming on port1 that match only FIRST_VPN.
Which two configuration changes must be made to both IPsec VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two.)
- A. Use different proposals are used between the interfaces.
- B. Specify a unique peer ID for each dial-up VPN interface.
- C. Use unique Diffie Hellman groups on each VPN interface.
- D. Configure the IKE mode to be aggressive mode.
Answer: B,D
NEW QUESTION # 41
What are two benefits of using forward error correction (FEC) in IPsec VPNs? (Choose two.)
- A. FEC can leverage multiple IPsec tunnels for parity packets transmission.
- B. FEC improves reliability of noisy links.
- C. FEC transmits parity packets that can be used to reconstruct packet loss.
- D. FEC supports hardware offloading.
Answer: B,C
NEW QUESTION # 42
Refer to the exhibit, which shows the IPsec phase 1 configuration of a spoke.
What must you configure on the IPsec phase 1 configuration for ADVPN to work with SD-WAN?
- A. You must enable auto-discovery-sender.
- B. You must set ike-version to 1.
- C. You must enable net-device.
- D. You must disable idle-timeout.
Answer: C
NEW QUESTION # 43
Refer to the exhibits.
Exhibit B -
Exhibit A shows the system interface with the static routes and exhibit B shows the firewall policies on the managed FortiGate.
Based on the FortiGate configuration shown in the exhibits, what issue might you encounter when creating an SD-WAN zone for port1 and port2?
- A. port1 and port2 are not administratively down.
- B. port2 is referenced in a static route.
- C. port1 is assigned a manual IP address.
- D. port1 is referenced in a firewall policy.
Answer: D
NEW QUESTION # 44
Which three matching traffic criteria are available in SD-WAN rules? (Choose three.)
- A. Type of physical link connection
- B. Source and destination IP address
- C. URL categories
- D. Application signatures
- E. Internet service database (ISDB) address object
Answer: B,D,E
NEW QUESTION # 45
Refer to the exhibit.
Based on the exhibit, which two actions does FortiGate perform on sessions after a firewall policy change?
(Choose two.)
- A. FortiGate flushes all sessions.
- B. FortiGate terminates the old sessions.
- C. FortiGate does not change existing sessions.
- D. FortiGate evaluates new sessions.
Answer: C,D
Explanation:
Explanation
FortiGate not to flag existing impacted session as dirty by setting firewall-session-dirty to check new. The results is that FortiGate evaluates only new session against the new firewall policy.
NEW QUESTION # 46
Refer to the exhibit.
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)
- A. Set load-balance-mode source-ip-ip-based.
- B. Set cost 15.
- C. Set priority 10.
- D. Set source 100.64.1.1.
Answer: B,C
NEW QUESTION # 47
Which two performance SLA protocols enable you to verify that the server response contains a specific value? (Choose two.)
- A. twamp
- B. dns
- C. http
- D. icmp
Answer: B,C
Explanation:
Pages 85,86 in Study guide 7.0 Pages 100,101 in Study guide 7
NEW QUESTION # 48
In the default SD-WAN minimum configuration, which two statements are correct when traffic matches the default implicit SD-WAN rule? (Choose two )
- A. The FIB lookup resolved interface was the SD-WAN interface.
- B. Traffic has matched none of the FortiGate policy routes.
- C. An absolute SD-WAN rule was defined and matched traffic.
- D. Matched traffic failed RPF and was caught by the rule.
Answer: A,B
NEW QUESTION # 49
Refer to the exhibit.
An administrator is troubleshooting SD-WAN on FortiGate. A device behind branch1_fgt generates traffic to the 10.0.0.0/8 network. The administrator expects the traffic to match SD-WAN rule ID 1 and be routed over T_INET_0_0. However, the traffic is routed over T_INET_1_0.
Based on the output shown in the exhibit, which two reasons can cause the observed behavior? (Choose two.)
- A. T_INET_1_0 has a higher member configuration priority than T_INET_0_0.
- B. T_INET_1_0 has a lower route priority value (higher priority) than T_INET_0_0.
- C. The traffic matches a regular policy route configured with T_INET_1_0 as the outgoing device.
- D. T_INET_0_0 does not have a valid route to the destination.
Answer: C,D
Explanation:
https://community.fortinet.com/t5/FortiGate/Technical-Tip-Assigning-Priority-to-SD-WAN-Members-for-Default/ta-p/230911
NEW QUESTION # 50
Refer to the exhibit.
Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?
- A. The type of traffic defined and allowed on firewall policy ID 1 is UDP.
- B. Firewall policy ID 1 has source NAT disabled.
- C. FortiGate has terminated the session after a change on policy ID 1.
- D. Changes have been made on firewall policy ID 1 on FortiGate.
Answer: D
NEW QUESTION # 51
Refer to the exhibits.
Exhibit A
Exhibit B
Exhibit A shows an SD-WAN event log and exhibit B shows the member status and the SD-WAN rule configuration.
Based on the exhibits, which two statements are correct? (Choose two.)
- A. SD-WAN rule ID 1 is set to lowest cost (SLA) mode.
- B. Port2 has the highest member priority.
- C. FortiGate updated the outgoing interface list on the rule so it prefers port2.
- D. Port2 has a lower latency than port1.
Answer: C,D
NEW QUESTION # 52
Refer to the exhibits.
Exhibit A -
Exhibit B -
Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SD-WAN member status, the routing table, and the performance SLA status.
If port2 is detected dead by FortiGate, what is the expected behavior?
- A. Host 8.8.8.8 is reachable through port1 and port2.
- B. Port2 becomes alive after three successful probes are detected.
- C. FortiGate removes all static routes for port2.
- D. The administrator manually restores the static routes for port2, if port2 becomes alive.
Answer: C
Explanation:
This is due to Update static route is enable which removes the static route entry referencing the interface if the interface is dead
NEW QUESTION # 53
......
Top Fortinet NSE7_SDW-7.0 Courses Online: https://www.trainingdump.com/Fortinet/NSE7_SDW-7.0-practice-exam-dumps.html
Free Fortinet NSE7_SDW-7.0 Exam Questions and Answer from Training Expert TrainingDump: https://drive.google.com/open?id=1MoS81pn40jrESr1PvS5kLY1MJlJgZP1w